Results 1 to 8 of 8
Thread: ‘Hover’ printing failure
Hybrid View
-
01-08-2021, 04:41 PM #1
- Join Date
- Jun 2014
- Posts
- 888
You'll want to locate the setting in your slicer for supports. Turn on supports and the slicer will create a print file that builds a series of walls or towers that sit where the droopies happen. After the print is complete, snap/cut/break them off and perform a bit of clean up.
-
01-08-2021, 04:49 PM #2
- Join Date
- Jan 2021
- Posts
- 3
Thanks! I’ll give that a try. Does it set up a support automatically for the print?
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery