Temperature resets to 0 mid-print Prusa i3 MK1

[Roberts_Clif]

You have a Prusa i3 I would think that you would want to use the best slicer PrusaSlicer 2.3.0 rc2 Has configurations for your 3D Printer.
Without the correct profiles any thing could happen.

Upon down loading PrusaSlicer and installing.
1st Run Select Configuration > Configuration Wizard > Prusa FFF and select your printer profile after you can select from many filaments.

[HGilbert]

Thanks. I downloaded the PrusaSlicer but the configuration wizard doesn't offer a configuration for the Mk I. Mk 2 and after are supported.

You have a Prusa i3 I would think that you would want to use the best slicer PrusaSlicer 2.3.0 rc2 Has configurations for your 3D Printer.
Without the correct profiles any thing could happen.

Upon down loading PrusaSlicer and installing.
1st Run Select Configuration > Configuration Wizard > Prusa FFF and select your printer profile after you can select from many filaments.

[Roberts_Clif]

Posted your comment on Prusa forum an hopefully some will post a solution.


an here is what the best had to say.
"the Mk1 is largely the same as the Mk2, (except for mesh bed levelling) and the Mk1 build space is 200 x 200 x 200mm and
I would take the mesh bed levelling code out for a Mk1 profile"