Extreme layer shifting Ender 3 v2

[Roberts_Clif]

Printed at 0.32mm layer height no layer shift

Tablet Holder.jpg

[Maxievr]

Printed at 0.32mm layer height no layer shift

Tablet Holder.jpg

Hmmm thats so weird. That would mean it is the printers or slicers fault. I will check my print when I go back home. Thanks for testing for me!!

[Maxievr]

I just finished my print and as you can see on the pictures it come out waaaaay better then the previous prints. But there was still some slight layer shifting at the top. (in both directions) And there was a lot of stringing (But that is obviously a different matter. So I am still not quite sure what the problem is because it is kinda solved but it still shifted a bit.WhatsApp Image 2021-01-03 at 00.39.45 (1).jpgWhatsApp Image 2021-01-03 at 00.39.45.jpg