On the Eryone I was printing at the default settings for the test cube and I did the same for the Ender 3 v2 for initial tests. The Ender prints great, the Eryone just wouldnt for the limited time it actually worked correctly (if you can even call it that)

The nozzle snapped/sheered off when trying to remove it. I didnt even use much force as I was worried about breaking the hot end. I am sure I would have been able to get it out and replace it but between that happening and the other issues with it I had lost faith in it.

The only positive the Eryone has over the Ender 3 v2 was how easy it was to build.