it's probably the best engineered machine creality have made.
The really interesting thing is that they're using a corexy setup.
But as far as I can see STILL using a bowden extruder. Just so not necessary.

But that little gripe aside it does look like a really solid bit of engineering.

I'm a fan of naomi's - and not for the two obvious reasons - to be honest I reckon the last implants were too much.

She works hard and puts out some interesting videos.

The only caveat is that they are using an 'off the shelf' standard conveyoir belt, originally intended for the short weighing stations you have in most factory prodution lines. This does give a zigzag pattern where the belts are stitched together.

The higher end belt printers all use custom bonded belts, but then they are a LOT more expensive, so you pays your money and makes your choice.

If you've got the money - it would be a good machine to get.
And one thing you can say about creality is that it's a kickstarter that will actully happen.