Hi, I am glad you are seeing better results. If it is glass you are printing on, one of the best tips I have come across is to clean the glass bed with washing up liquid prior to printing, and avoid at all costs touching the glass when drying it with paper towels as you will be transferring finger grease and oil back onto it. This gives me perfectly smooth bases to my models and I do not tend to have bed adhesion issues with doing this and there is no glue or painters tape to worry about. smaller models you can get away with cleaning it only every so often, but I tend to clean the bed with washing up liquid prior to any large print. I have achieved several full 30x25cm prints on a CR10 doing this, which leaves no room for a brim to assist.