Subscribe to Our Newsletter Advertise
Close



Results 1 to 4 of 4

Hybrid View

  1. 11-26-2020, 10:36 AM #1
    yacinebmr
    yacinebmr is offline
    Student
    Join Date
    Nov 2020
    Posts
    2
    thanx for your reply i've set the Vref on the drivers at 0.55V ( my steppers are 1.3A) . the voltage at the power supply and the ramps is 12.2V. the motors are not even fixed to the printer any more, i've set them free until i finish the tests
    Attached Files Attached Files
    Reply With Quote Reply With Quote
  2. 11-27-2020, 08:00 AM #2
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    Noted your Vref current settings.
    This is Mine for both 12 v and 24 volt 3D Printer Systems.
    Hictop Axis Stock 12volt 24volt
    X-Axis 0.8 0.695 0.395
    Y-Axis 0.8 0.695 0.395
    Z-Axis Dual Stepper 1.0 1.396 0.710
    E0 0.8 0.695 0.395
    E1 0.8 0.695 0.395
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules