Results 1 to 10 of 23
Thread: Real World 3D Printer Comparison
Hybrid View
-
11-30-2020, 04:53 PM #1
You can save that. You will need a new ptfe liner. But a torch on each part until it glows will clean them and turn anything inside to ash. I do that to clear plugged nozzles. Just get them hot until they glow and they are as good as new. Every time. I am printing your cat right now. S3D said 1hr 8 minutes. We will see. I am printing it in white so we can compare. Get that printer back together. This thread is just getting warmed up.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion