Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 23

Threaded View

  1. 11-23-2020, 10:43 AM #6
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    Here is a 1st Print - Have never tried this before and will print again as Cura 3.6.0 did this model no justice.

    Layer .24
    Print speed variable throughout the Model
    No Supports
    Photo taken at 2 hours 39 minutes]
    Final Time was 2 hours 52 minutes.

    2-39 Here.jpg

    Final.jpg

    Almost embarrassed to show this Print
    Will change slicer an make changes to the slicer profile post again.
    Last edited by Roberts_Clif; 11-23-2020 at 10:57 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules