Real World 3D Printer Comparison

[Roberts_Clif]

Here is a 1st Print - Have never tried this before and will print again as Cura 3.6.0 did this model no justice.

Layer .24
Print speed variable throughout the Model
No Supports
Photo taken at 2 hours 39 minutes]
Final Time was 2 hours 52 minutes.

2-39 Here.jpg

Final.jpg

Almost embarrassed to show this Print
Will change slicer an make changes to the slicer profile post again.

[Roberts_Clif]

3rd Print 2 hours 28 minutes and I found some tricks, believe I can cut this time down to about 2 hours.


2 Hours 28 Minutes.jpg

Will Post all Prusaslicer profiles after the Last print.

Now this is more like the model I wanted to Print.
Same settings just on a better Slicer.

2 Hours 21 Minutes.jpg

Shaved 7 minutes off the Print2 hours 21 minutes maybe could save another 7 minutes.
I think 2 hours 28 minutes is about the limit.

Show me your Print.