Results 1 to 10 of 13
Thread: ATMEGA blew up
Threaded View
-
11-21-2020, 03:26 PM #13
I truly believe that the print times are so close that we both won.
Both of us have figured out how to print the very best in the fastest time.
I wish I could get a faster print time and you probably also want a faster print time.
I can print faster though the models start look not so well and the the layer are not well laminated.
Have even upped the nozzle temp with the printer speed helped a little though still sacrificed the model quality and lamination even printing in a heated enclosure.
I have never had any problems with my current controllers other than the two I killed the stepper motor drivers IC chips on.
Did we loose you EmperorShaohao this was your thread and we still want to help you just got side tracked.Last edited by Roberts_Clif; 11-21-2020 at 04:47 PM.
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help