Which control board?

[AutoWiz]

I went with the 500-24 because that’s what they were selling on the net as an upgrade for the e5+. I thought it had to be 24v because the components are. I heard reprap is easier to setup. I thought Marlin could be run on all boards and is more widely used. My bad on that. I am becoming more knowledgeable each day with how these things operate. Installed my DIrect drive Swiss extruder today. PS coming Wednesday. Other small stuff coming thurs and Friday. Board should be here in a day or 2 with the display. I’m def gunna need help setting all this up lol. I’m in IT so I can handle the tech stuff. Most PS that are not 80 bronze or gold or whatever are only 70-75% efficient. So I would prob get closer to 400 on the 500.

Woa. My bad guy. I knew Meanwell made good power supplies but this conversation made me go and check and so far everything Meanwell I am looking at is 80 plus with the exception of a 5v power supply: https://www.meanwell.com/productPdf.aspx?i=469 . If yours is the RSP 500-24 then it is up to 90.5% efficient: https://www.meanwell.com/productPdf.aspx?i=467 . I hate being wrong and spreading bad info. Sorry dude. Also I thought your stuff was 12v. 24v is awesome and your PS is perfect by my standards.