Subscribe to Our Newsletter Advertise
Close



Results 1 to 8 of 8

Threaded View

  1. 08-03-2014, 10:42 PM #5
    PJMoore
    PJMoore is offline
    Student
    Join Date
    Aug 2014
    Location
    Tennessee USA
    Posts
    1
    It looks like you are only printing a single full top layer. Try making it print two or three layers on top. That is, once the extruder is calibrated on e-steps, and you measure the filament like the folks here said.
    Last edited by PJMoore; 08-03-2014 at 10:50 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules