Twisted box - new version

[curious aardvark]

lol - I owe simplify3d an apoloogy. Just started the 0.3mm box off. And it turns out that the 3 hours and 9 minutes it took to print at 0.16 was EXACTLY the time s3d said it would take.
I just read it wrong - oops :-)
so the 0.3mm should take 2 hours and 12 minutes.

yet another BOMI error (Bifurcated. Organic. Mobile. Interface)

I also set it for 60mm height, instyead of 50 - which explains why it took longer than would be expected for somethintg with almost twice the layer height.

Prints well, obviously visible layers. But fully functioning.