Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 36

Hybrid View

  1. 11-02-2020, 06:05 AM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    Quote Originally Posted by crazymonke42 View Post
    the filament did not look very melted though
    Quote Originally Posted by crazymonke42 View Post
    so i loosened the bolt that was holding the thermistor and plugged it back in and it is reading 26 also it is putting out filament now
    Is this a different filament that you have never used before?
    Which filament are you using?
    How old is the filament?
    How was the Filament stored?
    What temperature was the Hot-End set?
    Reply With Quote Reply With Quote
  2. 11-03-2020, 08:21 AM #2
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    Here is a setup for the Model below
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules