Results 1 to 6 of 6
Threaded View
-
10-13-2020, 12:05 PM #5
Well as soon as I took it apart is was clear. A small piece of filament had broken off and was stuck sideways blocking the entry hole in to the hot end. Damnit I should have just took it apart and looked. It is working great now. I cleaned it and the teeth on the drive gear and tested it to perfection. I am going to do a dual head print as a full test in a few minutes.
Thank you again Aardvark for your wisdom.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials