Results 1 to 10 of 18
Thread: prusaslicer versus simplify3d
Hybrid View
-
11-06-2020, 01:16 PM #1
you don't need to use s3d to know whether or not a slicer lets you apply difference sets of parameters to one print or a different set of parameters to each print on the print bed.
:-)
-
11-06-2020, 08:07 PM #2
In this area have not done anything because do not have the ability too,
You could call me a newbie, guess I do not completely understand some of what you are referencing.
This is OK I will pick it up from reading more forum posts.
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help