I can not do that at this point in my skill level with the 3d design software. If you can correct the model for me, I will print it and buy the motor and make it fly on HD video, upload it to youtube, and link it here. I scale it to 590mm on Z and before you scale it you need to remove 0.2mm from the bottom. There is a flaw in the model and when we scale it up it becomes noticeable and there are missed spots at the first layer or two so we need to just remove the slightest amount and we get a good print. I am not capable of even this. I know it is really far off-topic but check out the fun I was having with this Jeep Trackhawk I converted to run on the E85: https://www.youtube.com/watch?v=HtZM4Sw72_E