I looked at them but my smooth rods are farther apart so those will not work. But no worries. I am going to drive this thing with a SKR PRO and 4 TMC2226 drivers. I think it would be absolutely awesome to have a printer with a glass bed that has sensorless homing for X,Y, and Z. It will make for less wires and a cleaner appearance. And it also wont matter if the bed falls to the ground every time the printer shuts off. It will level itself as it homes with the sensorless homing. I flipped the bearings upside down so the length of them sticks up and don't ya know all 4 bottom out on the top of the frame at a very good place to just use the bed screws to adjust the bed height for the first layer. So now I wish I didn't buy that BLTouch. Maybe I will send it back when it comes.