Results 1 to 2 of 2
Thread: Good adhesion except one corner
Threaded View
-
10-04-2020, 10:31 AM #2
- Join Date
- Sep 2020
- Posts
- 4
You are still printing too high, so further adjustment of Z offset is needed. Graphic for reference:
first_layer-768x433.jpg
If you still have curling in the corner, after perfecting first layer, then collision might have done some damage - could be either BLTouch or mechanics of the printer (axis alignment, X/Y carriage, bed surface, etc)
Then i would have few additional questions:
Can you do probe repeatability test?
Do you have enabled ABL? Did specified compensation (settings or gcode)?
Is extruder carriage (x axis) perpendicular to bed (y axis)?
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials