Quote Originally Posted by frierson22 View Post

As far as the hot bed, a lot of what I read about that blamed it on the connectors.
They are pretty shaky and with the bed being in constant motion, that's where it fails and sometimes burns the connector.
Glad to see you decide of a new power supply!

Heat is generated from the weakest link the
1. - smaller Wire causes the majority of Hot Bed heating Problems.
2. - Controllers Mosfets being under rated.

Both of these can easily be fixed.
1. Use Larger Wire - (You Have Completed this)
2. Only need to do this if it continues to overheat.

There are a lot of people a lot there telling us that we need an expensive Controllers that our controllers will not work.
Wrong they are totally incorrect my smaller cheaper Chinese controller has never failed me.

However I have failed them by making a small mistake now they are dead. This does not make my controllers BAD!!!

Post a Picture of the burnt connectors.