Results 1 to 9 of 9
Thread: First Time Buyer help
Hybrid View
-
09-15-2020, 03:22 AM #1
- Join Date
- Aug 2020
- Location
- United Kingdom
- Posts
- 249
Unfortunately as aardvark says not all nylons (or any other material ) filaments are the same. Earlier this year when we decided to set up a small 3d printing facility for our Science Consultancy we tried a wide range of Nylon Filaments some as cheap as £15 per Kilo up to some £64 per kilo. Of those we tested with our simple machine we could only get good prints with 3 off those we tried Taulman Nylon 230 Taulman Bridge and Spectrum Filaments PA6 Low Warp. The £15 filament !! when we could get to stick on the base plate split between layers under its own internal stresses before it completed a print. The 3 filaments above print reliably every time.you get what you pay for!!
-
09-15-2020, 03:25 PM #2
- Join Date
- Sep 2020
- Posts
- 5
Interesting! Ideally I would have my own printer and be able to test different materials. One day I will own my own printer and have my way with testing different filaments. Online advice and many print attempts should hold me down for now. Thanks again for the help!
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion