Results 1 to 10 of 18
Threaded View
-
09-16-2020, 10:37 AM #13
- Join Date
- Sep 2020
- Posts
- 4
I am having a similar problem. BLTouch is not functioning correctly. It thinks one side of my bed is 5+ mm above the other side. After that first G29, it crashed straight into the bed on a first layer calibration.
I turned off G29 and got the calibration first layer to print perfectly with just the z-offset setting. I then just immediately hit reprint with zero changes and it is shooting spaghetti 2mm off the plate. What could cause 2 back to back prints to be different?
I am on an Ender 3 Pro with TH3D_UFW_U1.R2.B5 firmware installed. I modified the firmware according to BLTouch and Teaching Tech on YT.
UPDATE:
Ran Bed Visualizer on Octoprint and got this error:
TypeError: WebGLRenderingContext.uniformMatrix4fv: Argument 3 could not be converted to any of: Float32Array, sequence.Last edited by pound; 09-16-2020 at 12:28 PM.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials