DeltaWASP 60×100 printing problems

[curious aardvark]

I was actually thinking of the stepper drivers and chipset on the board overheating.

Never actually seen the innards of a wasp delta - seen the machines, but not taken one apart.

But as far as I rmemnber all the electronics are housed in the base and it's sealed, so with really long prints the heat will build.
Unless I'm thinking of a different make - but there aren;t that many companies making really big deltas - so I've probably got the right ones :-)

a 10 day print !
What are you making !?

Okay this is the printer in question:


So probably not heat build up - there should be ample room in the base for proper heat dissipation.
That is one big beast !

Reminds me - I've got about about 90% of the bits for a 350x1000mm delta in various places in my workshop. Really need to find the time and inclination to finish building it :-)

OR - work out how big a corexy I could make using the same 30x30 extrusion. Hmmmm......

Anyway i Digress.
With a printer like that the manufacturers really should give you decent support. Cheap it ain't.