Results 1 to 10 of 11
Thread: Filament Clogs Extruder
Threaded View
-
09-03-2020, 07:52 PM #4
- Join Date
- Jun 2014
- Posts
- 887
I usually print ABS at 250°C, but I've determined that the reported/set temperature is likely lower than reality. Even my PLA runs about ten degrees hotter than "internet average." Because you have a high temp limit, consider to slow the print speed by about 10-15 mm sec. It's a drastic change, but this is only a test. If you find that the clogging goes away, there's insufficient thermal mass to keep up with the material flow/speed.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials