Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 25

Hybrid View

  1. 04-17-2015, 04:03 PM #1
    AbuMaia
    AbuMaia is offline
    Engineer
    Join Date
    Jul 2014
    Location
    Eastern Colorado
    Posts
    536
    Quote Originally Posted by Melzk View Post
    how can i get rid of the ripples there is on the 11 and 12,
    i dont mean the layer lines, i mean that the layer lines arent aligned
    It looks like you have Z wobble/backlash. Are your Z rods constrained at the top and bottom? Do they sway as the Z goes up and down?

    You might look into using this http://www.thingiverse.com/thing:769057 on each side to see if that gets rid of the ripples. Use one spring and two nuts in each.
    Last edited by AbuMaia; 04-17-2015 at 04:54 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules