Subscribe to Our Newsletter Advertise
Close



Results 1 to 7 of 7

Hybrid View

  1. 09-08-2020, 06:19 PM #1
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    I agree you appear to be about 5mm above the hot-bed surface, this distance should only be one layer height above the print Bed.
    Example : layer set to 0.28mm the the height of the nozzle should be ~0.28mm height.

    Found a good demo video of how the 1st layers should look

    Last edited by Roberts_Clif; 09-08-2020 at 06:26 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules