Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 15

Hybrid View

  1. 10-08-2020, 01:27 PM #1
    YellowGTM
    YellowGTM is offline
    Student
    Join Date
    Jul 2020
    Posts
    20
    Looking for one last attempt before I toss this printer out the window.

    After $150 in upgrades, shipping, etc. I'm still not getting anywhere. The entire printer is nearly rebuilt INCLUDING a new mother board (quiet drive technology), entire hot end assembly, and aluminum feeder, and bed substrate.

    Still getting jams at the hot end, but more an issue is Adhesion to the bed.I've tried:

    - bed temp from 65-75 (normally set to 70).
    - Nozzle 200 degrees
    - bed clearance 1 sheet of paper "tight, or loose resistance"
    - 0.003" - 0.005" with feeler gauges even!
    - Fan 0, Fan 75, Fan 100
    - Flow 75, or 100
    -3 brands of PLA (also happens with PETG, but let's not go there!)

    LAST SETTING FOR PHOTO BELOW:
    200 nozzle, 75 bed, flow 75, 0.005" bed, fan 100


    WHAT WOULD JESUS DO!!!???!!! ender1.jpgender2.jpg
    Last edited by YellowGTM; 10-08-2020 at 03:54 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules