You know I have never actually opened a sliced file to look at the gcode before. Terrible ain't it? Well I looked at a few different single filament gcode files as well and it is not hard to understand at all. But i do not understand what switching to another extruder should look like. This is the diamond hotend. It needs no retraction or anything just to start using a different stepper for E. I opened the sliced 3 color lizzard and scrolled down to where the first 'toolchange' should happen and i believe this is the exact point my machine chokes. But i do not know if it is good or what using e1 now instead of e0 would look like as gcode. Here is where the gcode changes filaments for the first time and where my machine hangs not like the print stopped but I have to cycle power to regain control of the printer. It freezes.