Printing Flex Filament with the Flashforge

[curious aardvark]

yep got to say so far filaflex is my favourite.
And I'm guessing if it'll work without adjustment in a flashforge creator it should work just as well in pretty much every other non-bowden machine out there as well.

But still got two more to try out over the weekend.

The trick is finding something that you actualy want a lot of. In this case rubber sling pouches :-)
They'll mostly be given away, but it's a good part to test, as with irregular shaped rocks, they take a bit of hammer.

One thing I've discovered - load at a relative low temp.
215-220. I use 220.
And the 1cm cubes I printed yesterday were all at 220.
I'll try lower next. Obviously the lower the temp you can print at the stiffer the filament is being pushed through your hotend and the cleaner and more precise it should print.