Some more PVA printing. I saw this interesting model and wanted to try printing it: https://www.thingiverse.com/thing:2429742. Used ABS and PVA. Had a couple of goes, the first try didn't work as the PVA didn't bond to the PLA properly and the second try needed some manual tuning for speeds etc and disabling fan for the PVA layers. But in the end the print was successful.

I let the part dissolve in water for quite a long time, about a week or so. I did change the water a couple of times. Could've been faster, but I wasn't in a hurry.
IMG_20201012_215759.jpgIMG_20201012_233248.jpgIMG_20201109_201104.jpg