Results 1 to 2 of 2
Threaded View
-
07-23-2020, 04:05 PM #2
- Join Date
- Jun 2020
- Location
- South Carolina
- Posts
- 55
So, I loosened the x belt. I cleaned and oiled all the bearings and checked the pulley. I still didn't find anything that looked messed up, but I did get a couple of good prints after doing all that. I could still feel the tension in a couple of places when I manually move it in the x direction. It sticks and takes and extra push to get it past. The last thing I tried had the same offset layers, so I stopped. I ordered a new belt and new rollers.They are going to take forever to get here and I don't know if that will even help.I'm still open to any suggestions.ThanksDonna
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help