Results 1 to 10 of 12
Thread: Ender 3 Z axis not moving
Hybrid View
-
07-13-2020, 12:06 PM #1
- Join Date
- Jun 2014
- Posts
- 885
If no Ender owners chime in, I'll need more information. Would you post an image of the control board?
-
07-13-2020, 01:40 PM #2
- Join Date
- Jul 2020
- Posts
- 8
20200713_203702.jpg
Here's the control board
-
07-13-2020, 01:52 PM #3
- Join Date
- Jun 2014
- Posts
- 885
That's a pretty tough angle for the photo, but I can see that the stepper drivers are on the main board and not easily swapped. I found an entry on Amazon with this board. The location you moved cables previously was on the board or on the motors?
-
07-13-2020, 02:02 PM #4
- Join Date
- Jul 2020
- Posts
- 8
Sorry for that shitty pic and I tried swapping both ways, on the steppers and control board. I replugged the Y into Z and looks like the motor is struggling very hard to move. I even checked the Voltage with a borrowed multimeter and even that seems fine.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help