Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 12

Hybrid View

  1. 07-13-2020, 01:40 PM #1
    Akhilk
    Akhilk is offline
    Student
    Join Date
    Jul 2020
    Posts
    8
    20200713_203702.jpg
    Here's the control board
    Reply With Quote Reply With Quote
  2. 07-13-2020, 01:52 PM #2
    fred_dot_u
    fred_dot_u is offline
    Staff Engineer
    Join Date
    Jun 2014
    Posts
    887
    That's a pretty tough angle for the photo, but I can see that the stepper drivers are on the main board and not easily swapped. I found an entry on Amazon with this board. The location you moved cables previously was on the board or on the motors?
    Reply With Quote Reply With Quote
  3. 07-13-2020, 02:02 PM #3
    Akhilk
    Akhilk is offline
    Student
    Join Date
    Jul 2020
    Posts
    8
    Sorry for that shitty pic and I tried swapping both ways, on the steppers and control board. I replugged the Y into Z and looks like the motor is struggling very hard to move. I even checked the Voltage with a borrowed multimeter and even that seems fine.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules