Help on overhangs

[curious aardvark]

how big is it supposed to be ?

well size regardless - that is not going to print without extensive supports

looking at yout print - there were no supports below the blade.

weird model - can't seem to get simplify3d to even put supports under the blade automatically

If it was bigger I'd say split it in half lengthwise and print each half seperately and glue together.

[oneredlime]

oh i did put supports beneath them but i think i didnt do the settings correctly.
i drew the model myself for now the length of it is like 10cm/4 inch?that is possible but im just looking for a way to do this as i also have problems printing fillets from the bottom up. feels like there should be some setting where i could do to make it support better and able to print nicely except that i don't know where it is.

edit: i drew the thing in like 20mm...so i scale it up to slice