Results 1 to 10 of 15
Hybrid View
-
06-21-2020, 09:04 AM #1
- Join Date
- Feb 2018
- Posts
- 25
By vent hole, do you mean just a hole?
I don't know if it is a good idea to seal the door. If I seal it and use only one fan, there is no air to go in. If I leave some gap perhaps just like a vent hole in your case, those toxic nano particles could leak out. What do you think?
-
06-21-2020, 09:55 PM #2
I have a plastic front which cover 90% of the front leaving about 10% of the bottom front that is used to draw air.
In the back of my enclosure I have a bathroom fan that is used to suck the smelly air to the outside of my house threw a vent.
-
06-22-2020, 07:44 AM #3
- Join Date
- Feb 2018
- Posts
- 25
-
06-22-2020, 09:04 AM #4
Photo
The Twins-2020.jpg
I had the Camera against the wall,
The Enclosure is a Full 4 x 8 foot sheet of plywood with two Clear 24w X 18h inch Plastic sheet hanging from a 4 foot hinge.
Leaving a 24 X 6 inch gap at the bottom, I have two thermometers one behind each 3D Printer.
The inside area is a single compartment with a bathroom fan in the rear and Dual Raspberry Pi's attached from top.
A light dimmer is attached on the right side to adjust the fan speed.
Hope this gives you an ideal
Here is a photo of my First ABS printed model for my MPCNC.
XY_C_Burly.jpg
For This Carriage
carriage.jpgLast edited by Roberts_Clif; 06-23-2020 at 09:37 AM.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials