Results 1 to 10 of 15
Hybrid View
-
06-22-2020, 09:04 AM #1
Photo
The Twins-2020.jpg
I had the Camera against the wall,
The Enclosure is a Full 4 x 8 foot sheet of plywood with two Clear 24w X 18h inch Plastic sheet hanging from a 4 foot hinge.
Leaving a 24 X 6 inch gap at the bottom, I have two thermometers one behind each 3D Printer.
The inside area is a single compartment with a bathroom fan in the rear and Dual Raspberry Pi's attached from top.
A light dimmer is attached on the right side to adjust the fan speed.
Hope this gives you an ideal
Here is a photo of my First ABS printed model for my MPCNC.
XY_C_Burly.jpg
For This Carriage
carriage.jpgLast edited by Roberts_Clif; 06-23-2020 at 09:37 AM.
Please explain to me how to...
Yesterday, 12:15 PM in 3D Printer Parts, Filament & Materials