Subscribe to Our Newsletter Advertise
Close



Results 1 to 4 of 4

Threaded View

  1. 06-11-2020, 06:53 PM #2
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,154
    Add Roberts_Clif on Thingiverse
    The controller shown in your image is from a Hictop 3D Printer family, I have many different though very similar Hictop controllers.
    All work with the same firmware. the first two do not have an onboard SD card slot relying on and LCD SD Card reader and the MPK v1 has a SD Card Reader.

    Base 1.3 - This controller has a Heat sink that I installed for added protection of Driver Mosfets

    Base 1.3.jpg

    MPX.3
    MPX.3.jpg

    MPK v1 - This is the newest Hictop Controller the others are scarce.

    MPKv1.jpg

    these controller cards are compatible with the Arduino Mega2560 and a ramps controller.
    If you need any assistance with firmware or finding a replacement Post.
    Last edited by Roberts_Clif; 06-11-2020 at 07:00 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules