Results 1 to 3 of 3
-
04-17-2020, 09:38 PM #1
- Join Date
- Mar 2020
- Posts
- 9
Wrinkle? Bubble? What would you call this?
Still new to printing and sometimes I see these "Errors" in the print that I dont know what to call them but my question is what causes them?
-
04-19-2020, 10:28 AM #2
that kind of wrinkle in the first layer is usually caused by the printhead being too close to the bed.
use thicker paper when calibrating the bed. Or add a z-axis offset in the slicer.
-
04-20-2020, 11:48 PM #3
- Join Date
- Mar 2020
- Posts
- 9
I set it tighter because I had a problem with prints not sticking very well, I first tried turning up the bed temp to 70c and that didnt help particularity in one corner for some reason and making it slighting closer did the trick, I dont notice any "elephants feet" so I didnt think it was too close. I will see if I can dable with the z-axis offset. Thank you.
New to 3d printing looking for...
Yesterday, 12:56 AM in Tips, Tricks and Tech Help