Subscribe to Our Newsletter Advertise
Close



Results 1 to 10 of 10

Threaded View

  1. 04-10-2020, 05:50 PM #7
    Demxsr
    Demxsr is offline
    Student
    Join Date
    Apr 2020
    Posts
    8
    Quote Originally Posted by Roberts_Clif View Post
    This could be a thermal issue, try cooling the controller and Stepper motor Drivers.
    Also if you happen to be near the 3D Printer after a few hours carefully touch the Stepper motors to see if they are overheating.
    everything is barely warm to the touch. I have heatsyncs on all the drivers with a fan blowing directly across them. Motors are not warm either during prints.
    Last edited by Demxsr; 04-13-2020 at 09:04 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules