Results 1 to 10 of 13
Thread: Marlin 2.0 Auto Leveling Problem
Hybrid View
-
04-01-2020, 11:47 AM #1
- Join Date
- Mar 2020
- Posts
- 8
I´ve tried your code:
#define LEFT_PROBE_BED_POSITION MIN_PROBE_EDGE + 10
#define RIGHT_PROBE_BED_POSITION (X_BED_SIZE - (MIN_PROBE_EDGE + 10))
#define FRONT_PROBE_BED_POSITION MIN_PROBE_EDGE + 15 // 8 For Your Sensor
#define BACK_PROBE_BED_POSITION (Y_BED_SIZE - (MIN_PROBE_EDGE)) // + 10 For Your Sensor
But it gives me an error message, maybe it´s called differently in 2.0
-
04-01-2020, 03:29 PM #2
They did Update this Code!!
// Set the boundaries for probing (where the probe can reach).
#define MIN_PROBE_EDGE_LEFT MIN_PROBE_EDGE + 10
#define MIN_PROBE_EDGE_RIGHT (X_BED_SIZE - (MIN_PROBE_EDGE + 10))
#define MIN_PROBE_EDGE_FRONT MIN_PROBE_EDGE + 8 // +8 For Your Sensor
#define MIN_PROBE_EDGE_BACK (Y_BED_SIZE - (MIN_PROBE_EDGE)) // + 33 For Your Sensor
So Sorry... Mistake
This is for the Newer versions of Marlin above alphaLast edited by Roberts_Clif; 04-01-2020 at 06:38 PM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help