Prints not sticking to new Borosilicate bed

[airscapes]

You need to figure out how to make the nozzle start .174 mm closer to the bed

[Bruce19]

After measuring the 4 cubes and all pretty close, I cleaned bed with acetone , the did the computer paper to dial in hot end nozzel distance. Also applied stick glue. Ane cell case is started and sticking

[Bruce19]

shi.......... still had warping so in cura I turned case 90degrees so it print across the bed as opposed front to back. before told to print, i cleaned bed, applied stick glue after print done still not happy with