Quote Originally Posted by curious aardvark View Post
well bridge is one of the taulman filaments I found to be stupidly hard to print.
Gave up in the end.

36.66mm/s
seems a bit fast - try 20mm/s and 260c
And switch speed to mm/s - just easier to make sense of and I don't have to keep dividing by 60 :-)

nylon 645 on the other hand is much easier to use and works quite well. Infinitely better than bridge, that's for sure.
Thank you: I did not know that there were different kinds of nylon. Shows you how often I print with nylon! I will buy some 645 and try that.