Close



Results 1 to 3 of 3

Hybrid View

  1. #1
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,818
    well bridge is one of the taulman filaments I found to be stupidly hard to print.
    Gave up in the end.

    36.66mm/s
    seems a bit fast - try 20mm/s and 260c
    And switch speed to mm/s - just easier to make sense of and I don't have to keep dividing by 60 :-)

    nylon 645 on the other hand is much easier to use and works quite well. Infinitely better than bridge, that's for sure.

  2. #2
    Technologist
    Join Date
    May 2015
    Posts
    107
    Quote Originally Posted by curious aardvark View Post
    well bridge is one of the taulman filaments I found to be stupidly hard to print.
    Gave up in the end.

    36.66mm/s
    seems a bit fast - try 20mm/s and 260c
    And switch speed to mm/s - just easier to make sense of and I don't have to keep dividing by 60 :-)

    nylon 645 on the other hand is much easier to use and works quite well. Infinitely better than bridge, that's for sure.
    Thank you: I did not know that there were different kinds of nylon. Shows you how often I print with nylon! I will buy some 645 and try that.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •