Results 1 to 3 of 3
Threaded View
-
03-26-2020, 02:39 PM #2
well bridge is one of the taulman filaments I found to be stupidly hard to print.
Gave up in the end.
36.66mm/s
seems a bit fast - try 20mm/s and 260c
And switch speed to mm/s - just easier to make sense of and I don't have to keep dividing by 60 :-)
nylon 645 on the other hand is much easier to use and works quite well. Infinitely better than bridge, that's for sure.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials