Results 1 to 4 of 4
Thread: Simple question for Newbie
Threaded View
-
03-18-2020, 06:09 PM #2
- Join Date
- May 2018
- Posts
- 564
If you plan on using the printer again in the next 12 hours I leave the filament installed. If not I pull up the tube and cut it an inch above the extruder.. i have a direct drive so that does not waste any filament and I can put the spool away. Next time I need to use it, I heat the hot end, back out the short piece and insert the end of the spool and I am ready to go.
Hope that helps
Please explain to me how to...
Today, 03:08 PM in 3D Printer Parts, Filament & Materials