Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2

Threaded View

  1. 02-19-2020, 03:12 PM #2
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,153
    Add Roberts_Clif on Thingiverse
    Having the eccentric nuts adjusted correctly is a must an your first goal.
    Having the Slicer configured for the Ender 3 is the 2nd goal.
    I would set a third goal of Setting up a few Profiles for different layer heights.
    Attached Files Attached Files
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules