Results 1 to 4 of 4
Thread: QiDi 1 layer shift issues
Threaded View
-
02-25-2020, 04:13 PM #4
- Join Date
- Feb 2020
- Location
- Calgary AB Canada
- Posts
- 5
Like I mentioned before. I am not an expert. I only had mine for maybe 3 weeks. I bought it used as well. I went through it and tightened it all up. Blew some air through it to make sure its clean. I am quite sure there was a setting in the user panel (on the printer) to return to factory settings or it was "initial set up" ... take this with a grain of salt I am not at home ATM. Then it did some calibration, asked me to level the bed and it was done. PLA. Slowest I printed was 30 mm/s. That was a straight up tube with no support and only 0.4mm wall thickness. So I needed it to stick before falling over, and 90 was stringy. I think the recommended is between 30 - 90 mm/sTravel speed is also set at 150... but I turn that down to about 100 mm/s No need to make it work harder. Run that and see if there is any difference. Also make sure your table adjuster screws are not maxed out.
Please explain to me how to...
05-17-2024, 12:15 PM in 3D Printer Parts, Filament & Materials