Results 1 to 4 of 4
Threaded View
-
05-04-2020, 02:18 PM #4
- Join Date
- Jan 2020
- Posts
- 6
A 300x300 silicon pad stuck to the bottom of the 400x400 aluminum print bed (which has an integrated 12/24VDC heating circuit that I'm not using) seems to be working quite well. The heat takes a minute or two to get through the glass, but it gets there and seems relatively even, though I haven't tried to print anything at the edges at this point. :-)
Ender 3 Neo - Jam Problem
05-08-2024, 03:06 PM in Tips, Tricks and Tech Help