Curious Aardvark:

I have been looking into Simplify3D as a slicer to use for my personal printer (just got a Qidi X-Plus; I like it so far). At work we use Repetier, which works well for our fairly simple designs. I have seen a lot of good things about Simplify3D, the biggest negatives seem to be the cost and the long periods between updates, so I will look into it a bit more before deciding. At the moment I am using Qidi's slicer (Qidi Print), and it does not seem to recognize small line, but this could very well be my fault and lack of understanding. I am still learning about how the various controls that can be utilized via the slicer (i.e. extrusion multiplier, etc.) to work around certain problems.